How to reconstitute a vial
Freeze-dried (lyophilized) powder has to be dissolved in liquid before it can be measured. The goal is simple: get all of it into solution, keep it clean, and don't damage it.
What you need
- The vial, at room temperature
- Bacteriostatic water (or whatever diluent the product specifies)
- A syringe large enough for the water volume (a 1–3 mL syringe works well)
- Alcohol swabs
- A sharps container
Steps
- Decide on water volume first. Use the calculator to pick a volume that makes your measurements easy to read. More water = lower concentration = more units per draw.
- Wash your hands and work on a clean surface.
- Swab both rubber stoppers (vial and water) with alcohol and let them air-dry.
- Draw the water. Pull air into the syringe equal to the water volume, inject it into the water vial, then draw out the water. This keeps pressure even.
- Add water slowly down the glass wall. Angle the needle so the stream runs down the inside of the vial instead of blasting onto the powder.
- Swirl gently. Don't shake. Roll the vial between your fingers. Shaking can foam the solution and damage fragile molecules.
- Let it sit. Some powders take a few minutes to dissolve fully. It should end up clear.
- Label it with the date and the concentration (for example "5 mg/mL").
If the solution stays cloudy, has particles, or changes color, don't use it.
Storage basics
| State | General guidance |
|---|---|
| Powder, unopened | Cool, dry and dark. Refrigerate if the label says so. |
| After mixing | Refrigerate (2–8 °C / 36–46 °F). Keep it out of light. Don't freeze unless the label says it's OK. |
Always follow the storage instructions that came with the specific product.
FAQ
Should I shake the vial to dissolve the powder?
No. Swirl or roll it gently. Shaking can cause foaming and may degrade delicate compounds.
How much water should I add?
It depends on how easy you want measurements to be. More water lowers the concentration so each draw is more units. Use the calculator to compare options.
Do the math instantly
Vial amount + water → concentration and syringe units. Open the calculator →